Toxicological Evaluations in Macrophages and Mice Acutely and Chronically Exposed to Halloysite Clay Nanotubes Functionalized with Polystyrene.

Halloysite clay nanotubes (HNTs) have been proposed as highly biocompatible for several biomedical applications. Various polymers have been used to functionalize HNTs, but scarce information exists about polystyrene for this purpose. This work evaluated polystyrene-functionalized HNTs (FHNTs) by comparing its effects with non-FHNTs and innocuous talc powder on in vitro and in vivo models. Monocyte-derived human or murine macrophages and the RAW 264.7 cell line were treated with 0.01, 0.1, 1, and 100 µg mL-1 FHNTs, HNTs, or talc to evaluate the cytotoxic and cytokine response. Our results show that nanoclays did not cause cytotoxic damage to macrophages. Only the 100 µg mL-1 concentration induced slight proinflammatory cytokine production at short exposure, followed by an anti-inflammatory response that increases over time. CD1 mice treated with a single dose of 1, 2.5, or 5 mg Kg-1 of FHNTs or HNTs by oral and inhalation routes caused aluminum accumulation in the kidneys and lungs, without bodily signs of distress or histopathological changes in any treated mice, evaluated at 48 h and 30 days post-treatment. Nanoclay administration simultaneously by four different parenteral routes (20 mg Kg-1) or the combination of administration routes (parenteral + oral or parenteral + inhalation; 25 mg Kg-1) showed accumulation on the injection site and slight surrounding inflammation 30 days post-treatment. CD1 mice chronically exposed to HNTs or FHNTs in the bedding material (ca 1 mg) throughout the parental generation and two successive inbred generations for 8 months did not cause any inflammatory process or damage to the abdominal organs and the reproductive system of the mice of any of the generations, did not affect the number of newborn mice and their survival, and did not induce congenital malformations in the offspring. FHNTs showed a slightly less effect than HNTs in all experiments, suggesting that functionalization makes them less cytotoxic. Doses of up to 25 mg Kg-1 by different administration routes and permanent exposure to 1 mg of HNTs or FHNTs for 8 months seem safe for CD1 mice. Our in vivo and in vitro results indicate that nanoclays are highly biocompatible, supporting their possible safe use for future biomedical and general-purpose applications.

Effect of Clinoptilolite and Sepiolite Nanoclays on Human and Parasitic Highly Phagocytic Cells.

Nanoclays have potential applications in biomedicine raising the need to evaluate their toxicity in in vitro models as a first approach to its biocompatibility. In this study, in vitro toxicity of clinoptilolite and sepiolite nanoclays (NC) was analyzed in highly phagocytic cultures of amoebas and human and mice macrophages. While amebic viability was significantly affected only by sepiolite NC at concentrations higher than 0.1 mg/mL, the effect on macrophage cultures was dependent on the origin of the cells. Macrophages derived from human peripheral blood monocytes were less affected in viability (25% decrease at 48 h), followed by the RAW 264.7 cell line (40%), and finally, macrophages derived from mice bone marrow monocytes (98%). Moreover, the cell line and mice macrophages die mainly by necrosis, whereas human macrophages exhibit increased apoptosis. Cytokine expression analysis in media of sepiolite NC treated cultures showed a proinflammatory profile (INFγ, IL-1α, IL-8, and IL-6), in contrast with clinoptilolite NC that induced lees cytokines with concomitant production of IL-10. The results show that sepiolite NC is more toxic to amoebas and macrophages than clinoptilolite NC, mostly in a time and dose-dependent manner. However, the effect of sepiolite NC was comparable with talc powder suggesting that both NC have low cytotoxicity in vitro.

Grafting of polystyrene on nitrogen-doped multi-walled carbon nanotubes.

Polymer grafting of polystyrene (PS) on nitrogen-doped multiwall carbon nanotubes (CNx) was successfully obtained by a "grafting from" technique. The production method involves the immobilization of initiators, using wet chemistry, onto the nanotube surface, followed by an in situ surface-initiated polymerization. The polymer-grafting carbon nanotubes synthesis includes the free radical functionalization of CNx and the "controlled/living" Nitroxide Mediated Radical Polymerization (NMRP). The obtained products were studied using several microscopic techniques as scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HRTEM), and electron energy loss spectroscopy (EELS). The characterization also includes thermogravimetric analysis (TGA), Raman spectroscopy, infrared spectroscopy, and electron spin resonance (ESR), among others. The analyzed samples were also compared with solutions fabricated by physical blending of the polymer and CNx nanotubes. These results indicate that the nanotube radical functionalization, the chemical grafting, and the polymerization reaction were obtained over CNx when NMRP method was successfully used, giving rise to a uniform PS layer of several nanometers grafted on the outer surface of the CNx nanotubes. Several properties of the PS-grafted CNx nanotubes were also studied. It is shown that the production method leads to a narrower distribution of the external diameters. Moreover, their solubilization in organic solvents is greatly improved. Finally, the dispersion of PS-grafted CNx into a PS matrix is studied to determine the differences in filler dispersion and interfacial adhesion strength, in comparison with nanocomposites elaborated with as-produced CNx.